EL455 Elliptical
9
STEP 3: CONNECTING ARM ASSEMBLY
•
Align the hole in the rod end bearings at the ends of the Connecting Arms (8&9) with the
hole in the bracket at the bottom of the Swing Arms (10&11). There is a sleeve spacer
already installed in the rod ends and held in place with a twist tie; make sure these spacers
do not fall out during assembly. The rod end bearing should be positioned to the inside of
the swing arm brackets. Install two 5/16" Bolts (104) through the left and right swing arm
brackets and the rod end and secure with 5/16" Flat Washers (80) and 5/16" Nuts (71).
