6 of 42
V 1.9
www.esavep.com
PASHW-003-100LD
2.2 Installation Notes
Professional
& qualified
installer
is required
The heat pump must only be installed by a suitably qualified
engineer. Failure to ensure this can cause damage to the unit and
may cause serious injury. The warranty on the unit will also be
invalidated if a suitably qualified engineer is not engaged to install
it.
Earthing
required
Please make sure that the unit and power supply are properly
earthed.
Refrigerant
If you are installing the unit in a small room, please give full
consideration to adequate ventilation being available in the event
of a refrigerant leak.
Installation
Site
Do not install the unit near a gas installation. This unit is
designed to be installed inside a building.
Site
consideration
Ensure that this unit is fixed securely to a suitable wall that is
capable of taking the load of the unit when full of water. Make
sure that you have a suitable facility to cater for the disposal of
condensate from the condensate drain on the unit.
Circuit
Breaker
Make sure that this unit is connected to the power supply via a
fused switched spur and a 13A Type C MCB.
Unit Upright
The unit must be installed level across the whole diameter.
Failure to install the unit level will mean that condensate can spill
over the lip of the cylinder.
2.3 Operating Notes
Do NOT
Do not push anything into the fan blades when running and make
sure that children cannot access the unit or play close to the unit.
Shut off the
power supply
If there is an unusual sound or smell coming from the unit, shut
off the power supply immediately and call your installation
engineer.
2.4 Moving and Repair Notes
Caution
This unit has a high centre of gravity. This unit must be strapped
down to prevent it falling over when in transit.
Suitably
qualified
engineer
When moving the unit or carrying out repair work please be sure
to use only a suitably qualified engineer.
