9910046 RevG April 2021
6. Install Module Low Side
PAGE
13
Cam Claw aligned
6.1
Cam Seat
Place module on Cam Seat and
align with Array Edge.
Ti
p: Ensure the module is vertical
and flush with Seat.
ALERT: Cam Claw is mis-aligned.
Cam Claw
Place Cam Claw over module flange.
Apply a small downward force to
make sure it is properly seated.
6.2
ALERT:
Install Mechanical Attachments before installing modules.
See Appendix D
R
Tip:
R dimension is found in
the Racking Construction Set.
See Sheet Title: Typical Array
Dimensions.
Tip:
Installing all East facing
modules prior to installing
West facing modules leads to
faster system assembly.
ALERT:
Do not leave modules in
vertical position, go immediately to
next installation step (high side install).
ALERT:
When forecasted wind gusts exceed 25% of the wind
speed listed in the Site Criteria Table of the Racking
Construction Set, all mounted modules must be complete
pairs (Domes) to avoid system damage.
Example of a typical good Cam Claw install,
after the module has been rotated down
and high-side has been installed
Scan here for
module
installation
video
Tip
: Cam Claw grooves may be
ignored for installation purposes
