Configuration
VME-PMC-CADDY/2
Hardware-Manual • Doc.-No.: V.1915.21 / Rev. 1.0
Page 17 of 43
3.1 Default Setting of the Coding Switches
The default settings of the board as delivered is shown in the following table.
The position of the coding switch can be taken from figure 5. In the following description they are
shown as if the board is viewed with the VMEbus connectors on the right (view from PMC slot side).
Coding switch
Setting Value
Description
SW600
8
OFF
1
SFAILEN Control Bit Reset Value
VMEbus Power Up Options
7
OFF
1
SFAILAI Control Bit Auto Clear
6
ON
0
Auto Slot ID Enable
5
ON
0
Geographical Slot ID Enable
4
OFF
1
not used
3
OFF
1
not used
2
OFF
1
VMEbus System Controller:
Default: System Controller Function disabled
1
ON
0
SW800
4
OFF
1
PMC module 1 is not configured as Monarch
3
OFF
1
PMC module 2 is not configured as Monarch
2
ON
0
PCI-Bus of the PMC module is set to the fixed value of 33 MHz
1
OFF
1
(PUPEN) reserved for future applications
*) For details on the evaluation of the bits see [1].
Table 5: Overview of the default setting of the coding switches
