
Correctly Wiring Electrically Isolated CAN Networks
6.1.2 Cabling
●
for devices which have only one CAN connector per net use T-connector and stub (shorter
than 0.3 m) (available as accessory)
Figure 6:
Example for proper wiring with single shielded single twisted pair wires
6.1.3 Termination
●
If the used CAN interface is not equipped with an integrated CAN termination and it is at an
end of the bus, use external termination plugs.
●
9-pin DSUB-termination connectors with male and female contacts and earth terminal are
available as accessories
CAN-PCI/405-B4
Hardware Manual • Doc. No.: C.2041.21 / Rev. 1.2
Page 19 of 29