ESCO Technologies ETS-LINDGREN SuiteSentry, Руководство по эксплуатации и установке

Страница: 15 / 34

Page 15 of 34
Wall Bracket Attachment: Wall Toggler Anchor Method
(continued)
Observe the following steps to install the Togglers into the drywall.
Drill a 1/2" (Ø13mm) hole. Hold metal channel flat alongside
plastic straps and slide channel through hole. Minimum
clearance behind wall: 1-7/8" (48mm)
TIP-Use the laminated short form sheet in paperwork packaging
to go flush to wall and catch the debris from drilling the large
hole!
Hold ends of straps between thumb and forefinger and pull
toward you until channel rests flush behind wall. Slide plastic cap
along straps with other hand until flange of cap is flush with wall.
Snap straps at wall by pushing side to side, snapping off straps
level with flange of cap.
Place item over flange. Insert bolt through item and tighten until
flush against item, then stop.
Use the supplied bolt with #10 flat washers in each of the
locations.
Figure 6.1, 6.2, 6.3, 6.4 Fastening Wall Toggler to Wall