ESCO Technologies ETS-LINDGREN 2301, Руководство пользователя

Страница: 9 / 26

9
Assembly and Installation
Pre-Installation Tasks
Pre-planning is essential for successful installation. Discuss requirements with your sales representative and request
dimensional drawings prior to construction of your site.
Before installing any components, follow the safety information in the ETS-Lindgren
Product
Information Bulletin
included with your shipment.
Ensure power is off and base is secured before proceeding with installation.
Positioner Installation
Proper installation of the 2301 Precision Positioner unit directly affects performance of the positioning system as well
as the accuracy of the test results.
1. Uncrate all parts. Check all parts for any shipping damage. Ensure a clear area is available to assemble the
positioner unit safely.
Do not discard packing material until the Turntable is fully assembled and correct operation is verified.
The 2301 Precision Positioner consists of:
• Variable speed turntable
• Lossy foam absorber to cover the positioner
• Vertical columns with tilt positioner
• Laser for aligning system
Customer provides RF, power, and control cabling to the top of the unit and to the EUT.
2. The center of rotation for the unit must intersect the line through the bore sight of the measurement antenna.
Use the included laser to verify alignment.
3. Place the unit so the positioner connections are easily accessible and located closest to available feed through
panels and power supply connections. Ensure the Model 2301 is connected to a power outlet that
supplies 208-230VAC 50/60Hz. Use the power cord provided with the Model 2301 to make this connection
to the system.
US shipments will include a NEMA type 6-15P electrical plug power cord.
International shipments will include a Schuko type electrical plug power cord.
The IEC power inlet assembly includes a filter and an illuminated power switch.
4. Connect the positioner to the included Ethernet-to-fiber optic converter using the included dual fiber optic cable
with type ST connections. The converter connects to the host computer via the included 0.9 m (3.0 ft) Cat5
Ethernet cable. Ensure the fiber converter TX line is connected to the positioner RX input connector, and the
fiber converter RX line is connected to the positioner TX output connector.