Escient FireBall MP-200, Руководство пользователя

Страница: 109 / 263

FIREBALL REMOTE CONTROL GUIDE WD049-1-2
12/9/2005
6640 Intech Blvd. Suite 250 Indianapolis, IN 46278 317.616.6789 phone 317.616.6790 fax www.escient.com
ƒ
Enter the factory reset code which corresponds to the FB button being reset:
o
“0082” for FB1
o
“0083” for FB2
o
“0084” for FB3
o
“0085” for FB4
ƒ The LED will again flash twice indicating the programming was successful.
Repeat these steps for each FireBall in your system, selecting a different FB button for each.
Programming the Universal Source Buttons
Use the following steps to program the AUX, CBL, DVD, TV, and RCV source buttons to
control other devices. The following table indicates which device types can be programmed on
which source buttons:
Source Button Device Assignment
TV TV
CBL
Cable, Video Accessories, Satellite, DSS
RCV Amplifier, Tuner, Phono, Misc. Audio, CD, Home Automation, MD
DVD VCR, Audio Cassette, DVD, LDP, DAT, PVR
ƒ
Locate the 4 digit device code for the device you want to control in Appendix A.
ƒ Press the source button to be programmed.
ƒ
Press & Hold the “Code Set” button on the remote until the LED flashes twice.
ƒ
Enter the 4 digit code using the remote’s numeric keypad. The LED will flash twice
indicating the code was accepted.
Note: If the LED does a single long flash then the entered code was not valid for that source
button.
See Appendix B for details and instructions for accessing the other various functions available
on the remote control:
Programming the Source Buttons to Control a Legacy FireBall Product
The FireBall remote can also be programmed to control a single FireBall H, E-40, E-120, MP-
100 or TuneBase 200. Any of the eight source buttons can be programmed to control one of
these FireBall products.
ƒ
Press the source button to be programmed.
ƒ
Press & Hold the “Code Set” button on the remote until the LED flashes twice.
ƒ Enter “987” using the remote’s numeric keypad. The LED should flash twice again.
ƒ
Enter “0086”. The LED will again flash twice indicating the programming was
successful.
Note: This programming feature sets one of the source buttons on the FireBall remote to
emulate the
FB button on the legacy FireBall product remote, therefore, you must set the
legacy FireBall device to use the “ FB ” source button within it’s Setup/Utilities/IR Remote menu.