4
EScale Grob G103C - Instruction Manual
1.
Locate the servo holes in the wings and
carefully remove the fi lm covering using a
new blade in your hobby knife.
2.
Trial fi t your servo to the servo frame and the
servo frame in the hole. Adjust if necessary
Connect the servo to a servo programmer or
receiver to set for neutral position.
Attach a 600mm servo extension lead to servo
and use the cord provided to pull the servo
lead through the wing..
3.
Use a ruler or straight edge to establish a
line for the control rod. Make sure the line
is perpendicular to the hinge line as shown.
Gently mark the horn position with a felt tip
pen.
4.
Also mark the area to be removed to allow
the servo horn to rotate without fouling.
FITTING AILERON SERVOS TO WINGS
