5
18. Repeat steps 1 through 12 on second table half.
19. Gently tap caster sockets #12 into U-support #7 on second table
half until flange on sockets touches the edge of the tube.
DO NOT
HIT CASTER SOCKET DIRECTLY WITH A HAMMER!
SET A PIECE OF WOOD ON CASTER SOCKET AND
HIT PIECE OF WOOD TO DRIVE CASTER SOCKET
INTO U-SUPPORT.
20. Insert casters #11 into caster sockets #12 on second table half.
21. Attach linkages #4 to the OUTSIDE of U-support #7 on second
table half. Use bolts #14, plastic washers #24 and hex nuts #15.
NOTE: Tighten locknuts #15 finger tight only. They will be
removed when the two table top halves are connected.
Figure 9
CAUTION:
AT LEAST TWO ADULTS ARE NEEDED TO
COMPLETE THE REMAINDER OF THE
ASSEMBLY!
22. Make sure the legs on the first table top half (the half with the name panel #5) are open. With one person on each side of the table, lift and set
table half on its legs. Place table against a wall as shown above to help stabilize table top half while second half is being attached. Be sure there
is enough room to connect second half.
23. Place a hex bolt #9 and a locknuts #15 on floor next to caster wheels (on both sides of the table half) so they will be handy for the next step.
24. With a person on both sides of the second table half, slide the second table half against the first table half. Remove locknuts #15 from bolts
#14 on second table half where U-support #7 and linkages #4 join. Align holes in name panels #5 (on first table half) with holes in U-
supports (on second table half). Secure second table half to top hole in name panel #5 using hex bolt #14 installed earlier and locknuts just
removed. Secure second table half to bottom hole in name panel #5 with the two hex bolts #9 and locknuts #15 you placed on the floor
earlier. Tighten locknuts snug but do not overtighten. These joints must pivot. At this point go back and tighten hex bolts #9.
BE SURE THE FIRST TABLE HALF YOU ASSEMBLED (WITH NAME PANELS #5
ATTACHED) IS STABLE AND AGAINST A WALL. DO NOT LEAVE TABLE HALF
STANDING UNATTENDED.
CAUTION:
UNTIL THE TABLE HALVES ARE CONNECTED THEY WILL NOT STAND ON THEIR
OWN. IT IS RECOMMENDED TO HAVE THREE PEOPLE TO CONNECT TABLE
HALVES. TWO TO STABILIZE TABLE AND ONE TO BOLT TABLE TOGETHER.
CAUTION:
Figure 10
Attach Strap #6 to the
INSIDE
of U-Leg #2.
