2
1. Lay table top #1 painted side down, on a smooth, flat
surface. Use the shipping container to protect the
painted surface of the table top.
2. Assemble the two “L” tubes and the center tubes that
make up the “U” Support and the “U” Leg. Align on
Table Top as shown in Figure 1.
Note: “U” Leg is
larger and wider than the U Support. The U-
leg should be installed on the end of the table
half with the end rail mounting holes.
3. Put plastic caps #13 on the end of U-leg #2.
Figure 1
7
U-support
All screws shown
are (#20) sheet
metal screws.
18
20
18
18
3
3
3
IMPORTANT: U-Leg is wider than U-support.
Make sure they are assembled exactly as
shown. If not, there will be a large gap between
table halves and table will not operate properly!
Figure 2
For aid in identifying hardware, see hardware identifier on page 7.
4. Align the holes in the Large U-clips #3 and the U-clips #18
with pilot holes in table top assembly and secure with twenty
four screws #20 as shown.
U-support
7
End Rail
Mounting
Holes
2
U-Leg
13
Plastic
Cap
13
Plastic
Cap
18
2
U-Leg
IMPORTANT:
Be sure that slot in the three U-clips #3 and the three U-
clips #18 all face the same direction (toward the middle
of the table with the U-support) as shown.
CAUTION:
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-
CLIPS (#3) AND (#18) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE
TURNED INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE TO YOUR
TABLE WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.
This end is the middle of the table
and has no stripe or pilot holes.
This end is the middle of the table
and has no stripe or pilot holes.
If you want to see a video on how to position the U-Clips go to:
http://www.escaladesports.com/customer-service/videos.html
