SCREWS (#77) MUST BE INSTALLED TO POLE AS DESCRIBED
IN STEP 3. FAILURE TO INSTALL SCREWS COULD RESULT IN
SERIOUS INJURY OR PROPERTY DAMAGE.
NOTE: Cordless drill required for screw installation. Do not over
tighten screws causing screws to strip. Once Screw heads
touch pole, STOP! Overtightening will cause Pole to Warp
and damage system.
NOTE: To install screws, it will be easier if you use a cordless
drill with 5/16” socket (instead of Phillips head).
NOTE: Screws #77, used in step 3, are Self Drilling screws and
can be installed without drilling pilot holes. However, it
will be easier to install screws if you drill 9/64” pilot holes
in bottom pole. WEAR SAFETY GLASSES if drilling holes.
Figure 5
18
25
BACK SIDE
DO NOT DUNK ON THIS UNIT .
DO NOT HANG FROM ANY PART OF THIS
UNIT , INCLUDING THE BACKBOARD, RIM,
SUPPORT BRACES OR NET
.
4L-8152-01
W
ARNING
!
DO NOT DUNK ON THIS UNIT .
DO NOT HANG FROM ANY PART OF THIS
UNIT , INCLUDING THE BACKBOARD, RIM,
SUPPORT BRACES OR NET
.
4L-8152-01
W
ARNING
!
77
77
Figure 4
DO NOT DUNK ON THIS UNIT .
DO NOT HANG FROM ANY PART OF THIS
UNIT , INCLUDING THE BACKBOARD, RIM,
SUPPORT BRACES OR NET.
4L-8152-01
WARNING
!
NOTE: Self Drilling screws
(#77) are used. Holes are
only on outside Pole. User
must insert screws through
BOTH POLES.
3.
Once the Top pole is to the 6” Mark on the Warning Sticker, lay
Pole Assembly on its side on two padded saw horses. Insert a
(#77) Screw into each 3/16” hole in top Pole, two on each
side of the Post Assembly. You will need someone to hold the
Pole assembly while inserting screws. Screw must go through
both Top and Bottom (Inner) Poles. Make sure to not strip
screws once they are all they way through. See
Figure 4
.
7
4.
Attach Post Ears (#30) to holes near the bottom of Top Post
(#3) using two Hex Bolts (#25) four Washers (#18) and two
Lock Nuts (#4).
Do not
tighten nuts (#4) completely until
instructed to do so. See
Figure 5
.
18
18
25
4
30
3
3
2
