10
10.
Note: Tighten bolts snug but, do not over tighten.
Board Arms must pivot freely
Figure 7
Figure 9
DO NOT DUNK ON THIS UNIT .
DO NOT HANG FROM ANY PART OF THIS
UNIT , INCLUDING THE BACKBOARD, RIM,
SUPPORT BRACES OR NET
.
4L-8152-01
W
ARNING
!
Figure 10
11.
12.
PLACING THE POST ON THE ANCHOR SYSTEM
REQUIRES AT LEAST FOUR CAPABLE ADULTS.
POLE WILL WANT TO LEAN WHILE ATTEMPTING TO
STAND IT UP ON ANCHOR BOLTS.
NOTE: Do not remove the nuts #35 you
BE SURE CONCRETE
HAS BEEN ALLOWED
TO CURE FOR AT
LEAST 3 DAYS
Note: Bottom nuts #35 can
be used for leveling system.
See
Step 12
.
PLA
YING SURF
ACE
35
(Bottom Nut)
Attach long leg of Upper Arms (#6) to Top Pole (#3), as
shown in
Figure 9
, using a bolt (#7), two flat washers
(#18), two spacers (#8) and one lock nut (#4).
Locate hardware needed to mount pole to anchor
bolts. You will need, eight flat washers (#37), four lock
washers (#36), four hex nuts (#35) and four thread
protectors (#34).
Put a flat washer (#37) on each anchor bolt. Lift post
onto anchor system and secure with one flatwasher
(#37), one lock washer (#36) and one hex nut (#35)
for each anchor bolt. Tighten Fasteners finger tight,
leave loose enough to level pole. Place a level on pole
and adjust bottom nuts #35 until pole is level (left to
right and front to back).
Tighten top four hex nuts
#35 tight.
Place a thread protector (#34) on each
anchor bolt. See
Figure 10
.
installed in step 2 (pg. 5).
