12
NEVER USE RIM WITH COVERPLATE REMOVED!
Figure 13
77
77
23
77
Screw #77
Detail A
Note: Make sure (#27) Rim
Pad is installed between Rim
(#28) and Backboard (#23)
17.
Note: Make sure (#27) Rim Pad is installed
between Rim (#28) and Backboard (#23)
Mount Goal Assembly (#28) and Rim Pad (#27) to
Backboard, as shown in
Figure 13
, using four bolts (#49),
four washers (#26), and four locknuts (#4). Tighten fasteners,
but leave them loose enough to level rim.
18.
Place a level across rim assembly and adjust rim until it is
level. Finish tightening the four nuts.
19.
Attach Rim Cover Plate (#32) using four screws (#33). See
Figure 13.
20.
Check all nuts and bolts and make sure everything is
tightened properly.
DO NOT over tighten
pivot points,
snug is tight enough.
21.
Use the Backboard Pads (#44) and (#45) as a template and
mark the hole locations on the backboard frame. See
Figure
13
Detail A
and
.
NEVER USE RIM WITH COVERPLATE REMOVED!
23.
Secure Backboard Pads (#44) and (#45), as shown, using
screws (#77). Note: Tighten screws tight but,
do not over
tighten.
22.
Drill 9/64" pilot holes into steel backboard frame. See
Detail A. Do not drill through both sides of
backboard tube frame.
Note: Cordless drill recommended for screw installation.
Do not over tighten screws causing screws to strip.
Note: Screws (#42), used in step 22, are Self Drilling
screws and can be installed without drilling pilot holes.
However, it will be easier to install screws if you drill
9/64” pilot holes. WEAR SAFETY GLASSES if drilling holes.
Note: To install screws, it will be easier if you use a
cordless drill with 5/16” socket (instead of Phillips head).
