- 9 -
STEP 5:
With the help of another adult, attach
P15
Net using
P18
Bungee
Cord onto outer perimeter of the frame as shown in
FIGURE 5
.
IMPORTANT NOTES:
Orientate net -
26 squares
horizontally
by
23 squares
vertically. Orientate secondary horizontal border
in the net towards the top of the net. Do not attach
P15
Net to
top tubes
P7L
,
P13
or
P8R
. Do not place
P15
Net over top
tubes
P7L
,
P13
or
P8R
.
1.
Tie off one end of
P18
Bungee Cord using a double knot to
the welded D-Ring on part P10R as shown in
DETAIL A
and
FIGURE 5
.
2.
With help of another adult, thread
P18
Bungee Cord through
P15
Net and frame welded D-Rings, following
FIGURE 5
arrows.
IMPORTANT NOTES:
A.
P18
Bungee Cord should be pulled tight.
B.
The welded D-Rings are 6” apart, and the net is a 3” mesh.
Thus, the general rule is to thread the bungee cord through
every other hole of the net
.
C.
On each corner D-Ring, pull bungee cord tight and tie a
single knot for ease of assembly.
3.
Upon completion of 4th side bungee cord / net attachment, tie off
a double knot on the same D-Ring of the first/beginning bungee
cord double knot.
4.
Bungee Cord should be tight on all four sides.
1 pc -
P15
Rebound / Goal Net
1 pc -
P18
256” Rebound / Goal Net Outer Perimeter Bungee Cord
PARTS REQUIRED:
THIS STEP REQUIRES TWO OR MORE ADULTS.
CAUTION:
Double Knot
Single
Knot
Start / finish in here
with double knot
Single
Knot
Single
Knot
P15
P18
DETAIL A
P10R
P8R
P7L
P13
FIGURE 5
IMPORTANT NOTES:
1.
Orientate net - 26 Squares hori 23 Squares vertically.
2.
Secondary Border in net must be located towards top of net.
Secondary Border in Net
26 SQUARES
23 SQUARES
