- 11 -
STEP 7:
Attach
P16L
&
P17R
Side Nets using
P20
Bungee
Cords onto each side of frame assembly as shown
in
FIGURE 7
.
IMPORTANT NOTES:
Each of the (4) corners will
require double
P20
Bungee Cord threading for correct
assembly. Please follow directions and diagrams
closely. Bungee Cord should be pulled only
taught
throughout these following assembly steps.
1.
Tie off the end of each
P20
Bungee Cord using a
double knot onto welded D-Ring on
P9L
and
P10R
Tubes (Left or Right Side Net Attachment) as shown
in
DETAIL B
and
FIGURE 7
.
2.
Thread bungee cord from the outside through corner
of top side net grommet and continue through the
corner D-Ring. Then continue back through the same
corner net grommet once again from the outside to
make a loop. Continue on to the first welded D-Ring
as shown in
DETAIL B
and
FIGURE 7
.
3.
Continue threading bungee cord around all (4) sides
of frame, threading Bungee Cord through all welded
D-Rings and side net grommets as shown in
FIGURE 7
.
IMPORTANT NOTE:
Please follow
STEP 2 above
for correct “corner / net attachment”.
4.
Upon completion of 4th side bungee cord / net
attachment, tie off a double knot on the same D-Ring
of first/beginning bungee cord double knot.
5.
Bungee Cord should be only taught and side net
should not be loose in any areas.
STEP 8:
Upon final placement of the Striker Trainer, install (4) pcs
P21
Ground Stakes onto the bottom and most outward (4) corner tubes and tap into the ground using a rubber mallet.
1 pc -
P16L
Left Side Net
4 pcs -
P21
Ground
1 pc -
P17R
Right Side Net
Stake
2 pcs -
P20
Side Net Bungee Cord
PARTS REQUIRED:
FIGURE 7
NOTE:
Warning
label on
this side.
(inside)
NOTE:
“G” and “Goalrilla”
logo on this side.
(outside)
Double Knot
P17R
P16L
P20
P9L
P10R
Corner Net
Grommet
DETAIL B
Corner
D-Ring
