ESCALADE GOALRILLA CV B3303F, Руководство пользователя

Страница: 6 / 16

GOALRILLA
TM
ASSEMBLY INSTRUCTIONS (Day 5)
TOOLS REQUIRED FOR THE FOLLOWING STEPS
1 - 15/16" open end wrench
1 - 15/16” socket and ratchet (optional) 1 - Level
1 - Tape Measure
1 - Rubber Mallet
1 - Set of Padded Saw Horses
1 - 9/16” Deep Well Socket & Ratchet
1 - 3/4” Socket & Ratchet
1 - 3/4” Open end Wrench
1 - Phillips Screwdriver
1 - Pair of Safety Glasses
1 - Ladder
Figure 4
5
5
13
14
15
3
3
18
18
19
19
2
Figure 3
Figure 3
Figure 3
47
24
47
48
47
2
2
48
25
25
47
2. Slide Actuator Sleeve (#15) over Actuator (#16) and place
near the top of Actuator and Actuator Sleeve until equal
amounts stick out on both sides of Actuator. See Figure 4.
Actuator Cap (#13) on top. Slide Pivot Tube (#14) in hole
NOTE: It may be necessary to use a rubber mallet
to tap in Pivot Tube.
6
3. Lay Pole (#2) on its side on two padded saw horses. Attach
Actuator (#16) to Pole (#2) using one bolt (#19), split
lockwasher (#18), washer (#3) and two plastic washers (#5)
to thread into each side of Actuator. See Figure 4. Tighten
bolts tight.
46
4.
NOTE: It is important for the installer to understand the
necessity of the Plastic washers (#5) provided. These
washers adequately space painted parts at all pivot points.
Neglecting the use of these washers will result in rusted
parts.
If insert it
into the top of the Pole (#2). It may be necessary to
use a rubber mallet to tap cap in.
Pole Cap (#46) is not already pre-installed
1. Attach Post Brackets (#48) to outside of brackets on back
of Post Assembly (#2). Secure with two Hex Head Bolts (#25),
four Flat Head Washers (#47) and two Locknuts (#24) in
each Bracket (#48). See Figure 3.