14
Set at 10 feet
Mark with
tape
15
Figure 14
Lowered all
the way down
Tape at
10 feet
Figure 15
15
Tape
17
16
15
29.
Remove the adhesive backing from the Height Decal
(#17). Next, carefully align and stick decal to backside
of steel actuator (#16) starting at the
10 ft mark first
.
Be sure to keep the height decal straight and rub out all
air bubbles. See
Figure 16
.
Do not
remove adhesive backing from height decal
(#17) yet. Carefully place height decal on backside of
steel actuator (#16) and line up the 10 ft mark on the
tape with the 10 ft mark on the height decal. Decal
should fit correctly onto the backside of the steel
actuator. ( If not , simply trim to fit the top of the
actuator decal).
28.
Raise Backboard to 10 FT. regulation
playing height. Measure from top of rim
straight down to the playing surface.
Using tape - mark the
side
of the steel
actuator (#16) just under the plastic
actuator sleeve (#15) at this 10 ft rim
height. See
Figure 14
.
Lower backboard all the way down. Do not
force actuator once backboard is in it's
lowest position. See
Figure 15
.
25.
26.
27.
Figure 16
