Preparing the ExpressVote XL for Use
ExpressVote XL Setup
Confirm the green power indicator light is
illuminated on the front status panel. This
indicates the ExpressVote XL is plugged into
AC power.
Lift the protective screen cover from the
touch screen. Unlock and open the Access
Compartment door on top of the terminal.
Inside the Access Compartment, press and
release the red power button. Once powered
on, the power light is illuminated.
Installing Privacy Curtain &
Adjusting Touch Screen Angle
Remove the curtain assembly from the storage
tube on the bottom back of the terminal.
Insert rods into the mounting brackets on
either side of cart. Loosen the white plastic
clamps on the assembly to adjust height, then
re-tighten.
Connecting Assistive Voting
Equipment
The Universal Voting Console (“UVC”) allows
voters to vote without using the touch screen.
The UVC plugs into the USB port in the Access
Compartment. Only one unit per polling
loction will have a UVC.
Headphones connect to the UVC via the
headphone jack on the bottom right corner.
Thread the UVC wire carefully through the
notch in the upper-left corner of the door as
you close it. Not doing so could cause damage
to the wire.
Touch Screen
Locking Pin
Mounting
Brackets
ExpressVote XL Universal Voting System | Poll Worker Guide v 1.1.PHI
Page | 7