ESAB Retrofit Aristo Mig 4004i WeldCloud, Инструкция по эксплуатации

Страница: 18 / 34

6 MAINTENANCE
0463 431 101 - 18 - © ESAB AB 2017
6 MAINTENANCE
CAUTION!
Only persons with the appropriate electrical knowledge (authorised personnel)
may remove the cover of the product or carry out service, maintenance or repair
work on the welding equipment.
CAUTION!
The product is covered by manufacturer's warranty. Any attempt to carry out
repair work by non-authorized service centers will invalidate the warranty.
NOTE!
Regular maintenance is important for safe and reliable operation.
For information about the cooling unit see the instruction manual for the cooling unit.
6.1 Inspection and cleaning
Check regularly that the power source is free from dirt.
The power source should be regularly blown clean using dry compressed air at reduced
pressure. More frequently in dirty environments.
Otherwise the air inlet/outlet may become blocked and cause overheating. To avoid this, the
air filter should be regularly cleaned. The filter is built of a large and a small mesh. Make sure
that the large mesh is mounted to the upmost part of the power source and the small mesh to
the innermost part of the power source.
Replacing and cleaning the dust filter:
1. Release the dust filter according to the figure.
2. Blow the filter clean with compressed air (reduced pressure).
3. Ensure that the filter with the finest mesh is placed towards the grill.
4. Reinstall the filter.