6
powder tube into the connection (185W05). Using
two wrenches, tighten the connection.
4.
Position the powder valve (55Y49) as shown in Fig. 2
with the lever in line with the cutting valve lever on the
torch. Connect and tighten the powder tube to the
powder valve and connect the powder inlet tube
(61Y53) to the powder valve inlet. Use two wrenches
to tighten the connections.
MAINTENANCE
ACV-2 Powder Valve:
To remove the stem and seat
(33Y46) for cleaning or replacement, remove clip and
lever pin, and lift lever and washer off valve stem. Then,
unscrew valve guide from valve body. The valve stem
and seat can now be lifted out. Replace valve stem and
seat assembly and any other parts which are worn or
corroded. Blow out all loose powder from valve and re-
assemble, being sure parts are in proper sequence (see
parts picture below).
Powder Adaptor:
The powder nozzle (61Y06) can be
replaced by simply breaking the connection and remov-
ing the nozzle from the clamp. The new nozzle is sup-
plied with a ferrule and nut for easy installation.
Fig. 2 - Powder Washing Attachment for C-62 ( 61Y01)
POWDER ADAPTOR ASSEMBLY-61Y05
(INCLUDES)
INCLUDES
(2) FERRULE-185W35
NOZZLE-61Y06
CLAMP-150Z99
(2) SCREW-6134-1991
CONNECTION-185W05
POWDER TUBE-147Z25
INSERT-73Z86
(SOFT SOLDER)
DIAPHRAGM-30Z55
1/8"-27 NPT
STEM & SEAT-33Y46
PARTS SUPPLIED
WITH-55Y49
4789-NIPPLE
36Z40-NUT
SECTION “B”-“B”
SILVER SOLDER
RING-38Z68
NUT-37Z25
CAP-31Z57
PIN-38Z34
SPRING-28Z20
POWDER VALVE ASSEMBLY
TYPE ACV-2 - 55Y49
(SEE VIEW “A”
FOR REPLACEMENT PARTS)
SILVER SOLDER
5/8"-18
POWDER INLET TUBE-61Y53
3/16"-24"
(2) WASHER-73Z98
CONNECTION-185W04
INCLUDES
FERRULE-185W35
1"-20
“B”
ELBOW-11Z73
THUMBSCREW-6135-1052
VIEW “A”
LEVER-25Z22
CLIP-81W53
NUT-185W40
FERRULE-185W35
BODY-80Z58
POWDER WASHING ATTACHMENT ASSEM-
BLY INSTRUCTIONS
Before attempting to use the powder attachment, read
carefully the instructions packed with your OXWELD
Powder Dispenser.
Attach to Torch
1.
Insert the powder nozzle (61Y06) through the
clamp. Slip the ferrule (185W35) and nut from com-
pression-type connection 185W05 over the end of
the powder nozzle. Be sure the heavy end of the
ferrule is towards the nut. Screw the connection
(185W05) into the nut. Using two wrenches, tighten
the connection.
2.
Assemble the cutting nozzle in the torch as shown
in Fig. 2 below. Locate the clamp on the torch so
that the end of the powder nozzle is flush with the
end of the cutting nozzle as illustrated below.
Tighten the clamp on the torch and on the powder
nozzle.
3.
Slip the ferrule 185W35 and nut from connection
185W35 onto the powder tube (147Z25) with heavy
end of ferrule toward the nut. Insert the end of the
Содержание OXWELD C-62
Страница 7: ...7 ...
