ESAB Origo Tig 3001i, Инструкция по эксплуатации

Страница: 21 / 32

-- 21 --
bt37e
6.3 Fan control
The power source has a time control that means that the fans continue to run for 6.5
minutes after welding has stopped, and the unit switches to energy--saving mode.
The fans start again when welding restarts.
The fans run at reduced speed for welding currents up to 110 A, and at full speed for
higher currents.
6.4 Overheating Protection
The welding power source has overheating protection that operates if the
temperature becomes too high. When this occurs the welding current is interrupted
and a fault code is displayed on the control panel.
The overheating protection resets automatically when the temperature has fallen.
6.5 TIG welding
TIG welding melts the metal of the workpiece, using an arc struck from a tungsten
electrode, which does not itself melt. The weld pool and the electrode are protected
by shielding gas.
For TIG welding, the welding power source is supplemented with:
S
TIG torch, see accessories page 27
S
an argon gas cylinder
S
an argon gas regulator
S
tungsten electrode
6.6 MMA welding
For MMA welding, the power source is supplemented with:
S
welding cable with electrode clamp, see accessories page 27
7 MAINTENANCE
Regular maintenance is important for safe, reliable operation.
Only those persons who have appropriate electrical knowledge (authorized
personnel) may remove the safety plates.
CAUTION!
All guarantee undertakings from the supplier cease to apply if the customer himself
attempts any work in the product during the guarantee period in order to rectify any faults.
GB