ESAB EMP 215ic, Руководство по обслуживанию

Страница: 12 / 102

ESAB EMS215C/EMP215C
1-4 SAFETY INSTRUCTIONS Manual 0463 413 001
4. If you develop momentary eye, nose or throat irritation while operating, this is an indication that ventila-
tion is not adequate. Stop work and take necessary steps to improve ventilation in the work area. Do
not continue to operate if physical discomfort persists.
5. Refer to ANSI/ASC Standard Z49.1 (see listing below) for specific ventilation recommendations.
6. WARNING: This product when used for welding or cutting, produces fumes or gases which contain
chemicals known to the State of California to cause birth defects and in some cases cancer (California
Health & Safety Code §25249.5 et seq.)
CYLINDER HANDLING
Cylinders, if mishandled, can rupture and violently release gas. Sudden rupture of cylinder valve
or relief device can injure or kill. Therefore:
1. Locate cylinders away from heat, sparks and flames. Never strike an arc on a cylinder.
2. Use the proper gas for the process and use the proper pressure reducing regulator designed to operate
from the compressed gas cylinder. Do not use adaptors. Maintain hoses and fittings in good condition.
Follow manufacturer's operating instructions for mounting regulator to a compressed gas cylinder.
3. Always secure cylinders in an upright position by chain or strap to suitable hand trucks, undercarriages,
benches, wall, post or racks. Never secure cylinders to work tables or fixtures where they may become
part of an electrical circuit.
4. When not in use, keep cylinder valves closed. Have valve protection cap in place if regulator is not
connected. Secure and move cylinders by using suitable hand trucks.
5. For additional information, refer to CGA Standard P-1, “Precautions for Safe Handling of Compressed
Gases in Cylinders”, which is available from Compressed Gas Association, 1235 Jefferson Davis High-
way, Arlington, VA 22202.
MOVING PARTS
Moving parts, such as fans, rotors and belts can cause injury. Therefore:
1. Keep all doors, panels and covers closed and securely in place.
2. Stop engine before installing or connecting unit.
3. Have only qualified people remove covers for maintenance and troubleshooting as necessary
4. To prevent accidental starting of equipment during service, disconnect negative (-) battery cable from
battery.
5. Keep hands, hair, loose clothing and tools away from moving parts.
6. Reinstall panels or covers and close doors when service is finished and before starting engine.
!
WARNING
FALLING EQUIPMENT CAN INJURE
• Only use lifting eye to lift unit. Do NOT use running gear, gas cylinders or any other
accessories.
• Use equipment of adequate capacity to lift and support unit.
• If using lift forks to move unit, be sure forks are long enough to extend beyond op-
posite side of unit.
• Keep cables and cords away from moving vehicles when working from an aerial loca-
tion.