ESAB AristoFeed 30- 4, Инструкция по эксплуатации

Страница: 7 / 26

-- 7 --
bm29d1ea
WARNING!
This product is intended for industrial use. In a domestic environment this product may cause radio
interference. It is the user’s responsibility to take adequate precautions.
WARNING!
When welding in an environment with increased electrical danger, only power sources intended
for this environment may be used. These power sources are marked with the symbol .
5.1 Lifting instructions
Ordering number for the lifting eye can be found on page 22.
Note! If another mounting device is used, this should be insulated from the wire feed
unit.
5.2 Terminating resistors
In order to avoid communication interference, the
ends of the CAN bus must be terminated by resistive
loads.
One end of the CAN bus is at the wire feed unit control panel,
which incorporates a terminating resistor. The other end is in
the power source and it must be fitted with a terminating resistor,
as shown in the diagram to the right.
GB