ESAB Aristo U6, Инструкция по эксплуатации

Страница: 18 / 46

4 TIG WELDING
0459 287 474
- 18 -
© ESAB AB 2016
- Setting of background current performed in the settings menu .
Pulse current
This is the higher current value of the two currents used in pulsed current welding.
Irrespective of which menu is displayed, the setting value for the pulse current can always be
changed. The value is displayed in the
main menu , the selection menu or the settings menu .
TIG welding with pulsing.
A = Current B = Time C = Background time
D = Background E = Pulse time F = Pulse current
Current
Higher current produces wider and deeper penetration into the workpiece.
Irrespective of which menu is displayed, the setting value for the current can always be
changed. The value is displayed in the
main menu or selection menu .
Change of trigger data
Using this function, it is possible to switch to various pre-set welding data alternatives by
double-clicking on the welding blowpipe's trigger.
Switching takes place between the memory positions 1, 2 and 3, see the “MEMORY
MANAGEMENT” chapter. If there is no data in memory position 2, switching takes place
instead between positions 1 and 3.
ON - Switching between memory positions can take place before , after or during welding.
ARC OFF - Switching between memory positions can only take place before or after
welding.
- Activation of trigger data switching performed in the configuration menu.
Min current (Remote min)
Used to set the minimum current for the remote control. If the max current is 100 A and the
min current is to be 50 A, set the min current to 50%. If the max current is 100 A and the min
current is to be 90 A, set the min current to 90%.
- Activation of min current performed in the settings menu .