ESAB Aristo RoboFeed 3004HW, Инструкция по эксплуатации, Страница: 9 / 26

4 INSTALLATION
0463 280 201
- 9 -
© ESAB AB 2014
4 INSTALLATION
The installation must be carried out by a professional.
WARNING!
When welding in an environment with increased electrical danger, only power
sources intended for this environment may be used. These power sources are
marked with the symbol
.
4.1 Terminating resistor
The ends of the CAN bus must be fitted with terminating
resistors to avoid communication interference.
The terminating resistor is delivered with the power source.
One end of the CAN bus is at the control panel (U8
2
), which
has an integral terminating resistor.
The other end is at the FeedControl and must be fitted with the
terminating resistor, as shown on the right.
If U8
2
is used together with W8
2
, the terminal resistor in the
W8
2
must be disconnected, see the instruction manual for the
W82.
4.2 Example of a robotic welding system
NOTE!
A mounting kit and a cable kit are required for mounting to a robot, please contact
your local ESAB dealer for more information.