ESAB Aristo RoboFeed 3004HW, Инструкция по эксплуатации, Страница: 8 / 26

3 TECHNICAL DATA
0463 280 201
- 8 -
© ESAB AB 2014
3 TECHNICAL DATA
RoboFeed 3004HW FeedControl 3004HW
Power supply - 42 V 50 - 60 Hz
Power requirement - 378 VA
Motor voltage 60 VDC PWM (Pulse Width
Modulation) -
Motor current I
max
8.0 A 8.0 A
Wire feed speed 0.8 - 30.0 m/min -
Torch connection EURO -
Wire dimension
- Steel (Fe) 0.8 - 1.6 mm -
- Stainless steel (Ss) 0.8 - 1.6 mm -
- Aluminum (Al) 1.0 - 1.6 mm -
- Cored wire (FCW) 0.8 - 1.6 mm -
Operating temperature -10 to +40°C -10 to +40°C
Transport temperature -20 to +55°C -20 to +55°C
Weight 5.4 kg 4.9 kg
Dimensions (l × b × h) 251 × 182 × 221 mm 330 × 118 × 320 mm
Shielding gas Gases for MIG/MAG welding Gases for MIG/MAG welding
- max pressure 0.5 Mpa (5 bar) 0.5 Mpa (5 bar)
Coolant - ESAB's ready-mixed coolant
- max pressure - 0.5 Mpa (5 bar)
Maximum permissible load at
- 60% duty cycle 500 A 500 A
- 100% duty cycle 280 A 280 A
Enclosure class IP2X IP2X
Duty cycle
The duty cycle refers to the time as a percentage of a ten-minute period that you can weld or
cut at a certain load without overloading. The duty cycle is valid for 40°C / 104°F.
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration
by solid objects or water.
Equipment marked IP2X is intended for indoor use.
Coolant
It is very important to use the ESAB ready-mixed coolant! If other coolants are used the
equipment could be damaged or in worst case the chassis could become live. You can find
the ordering number of ESAB's ready-mixed coolant in the "ACCESSORIES" chapter of the
instruction manual.