-- 73 --
ffa9d1ea
S
For twin wires 2 x 2.0 -- 3.0 Heavy Twin (D35) (Accessories)
Use the straightener (3), connector (1) D35 with contact
jaws (2).
S
Fit the first contact jaw with the M5 bolts supplied, in the
fixed connector (a).
S
Fit the other contact jaw in the free half of the two--piece
connector (b) under the bolt (8) and tighten down hard to
ensure that a good contact is achieved between the
contact jaws and the wire.
S
For twin wire 2 x 1.2 -- 2.0 mm, Light Twin (D35) (Accessories)
Use the straightener (3), connector (1) D35 with twin
adapter (9) and 2 contact tips (2) (M6 threads) and separate
fine wire straightener (4) with two guide tubes (6). For twin
wire < 1.6 mm, insert a guide spiral into each guide tube.
S
Fit the twin adapter (9) for M6 contact tips (2) with the
M5 bolts in the fixed half of the two--piece connector
(1).
S
Fit the clamp (7) with guide tube (6) in the M12 hole on
the standard straightener (3). The guide tube should
bottom on the twin adapter (9) for the contact tip (2).
S
Tighten the contact tip (2) with a key to ensure that a
good contact is achieved.
S
If necessary, cut the guide tube (6) to length so that the
feed roller (5) runs freely.
S
Adjustment of the wires for Twin--arc welding:
S
Position the wires in the joint so as to achieve optimal weld quality by
rotating the connector. The two wires can be rotated so that they are
positioned one after the other along the line of the joint, or in any position
up to 90
˚
across the joint, i.e. one wire on each side of the joint.
GB
