ESAB 0700 200 015, Инструкция по эксплуатации

Страница: 9 / 20

© ESAB AB 2005
- 9 -
bg17e
6.2 Replacing tip adaptor
1.
a. Undo the tip adaptor using an appropriate tool.
Prevent the swan neck from rotating using universal pliers.
b. Fit in reverse order.
6.3 Replacing contact tip
1.
a. Prevent the tip adaptor from rotating
using an adjustable wrench.
b. Undo the contact tip using an
appropriate tool.
c. Fit in reverse order.
6.4 Replacing feed roller
Select correct feed roller for wire dimension.
Please note that each feed roller is intended for
a specific wire dimension, and on delivery a feed roller
for 1.2 mm wire is fitted.
1.
a. Remove the cover (1) on the welding
gun by lifting it straight up.
Prevent the feed roller (2) from
rotating using a 2 mm (approx.)
steel shaft (a small screwdriver
or an Allen key).
b. Undo the screw (3) holding the
feed roller using a screwdriver.
c. Lift the feed roller straight up and insert a new one. Ensure that the feed
roller tracks are in the correct position and replace in reverse order.
The pressure on the feed rollers can be adjusted if necessary using two screws
located on both sides of the gun.
GB