Page 8 total 3
2.2 Installation instructions
2.2.1 Installation steps
1.Refer to the user manual to correct all Jumper adjustments on the motherboard.
2.Install additional expansion cards.
3.Connect all signal lines, cables, panel control lines, and power supplies.
4.Start the computer and complete the setup of the BIOS program.
The key components of this motherboard are integrated circuits, and these components are easily
damaged by static electricity.
Therefore, before you formally install the motherboard, be prepared as follows:
1.
Hold the board when holding the edge of the board, as far as possible do not touch the
components and plug socket pins.
2.
It is best to wear anti-static bracelets/gloves when touching integrated circuit components (e.g.
CPU, RAM, etc.).
3.
Before the integrated circuit components are installed, the components should be placed in an
anti-static pad or anti-static bag.
4.
Plug in the power supply after confirming that the switch to the power supply is in the open
position.
2.2.2 Memory installation.
There are two things to note when installing a memory bar:
1.When installing, align the notch of the memory strip with the notch of the slot and tighten it hard.
2.When selecting a memory bar, you must select a memory bar that supports this board
specification.
2.2.3 Jumper settings.
Before installing your hardware device, follow the table below to set up the jumpers according to
your needs.
Tip: How to identify the jumper, the first pin of the interface.
Observe the text mark next to the plug socket, which will be added with the "1" or Thick lines or
triangle syllables; look at the pad on the back, square pad is the 1st pin; all jumpers have the first pin
next to 1 triangular symbol.