Page 34 total 3
Pxe
The pre-boot execution environment is used to run software over the network that does not have hard
disk data for PCs.
S3
Turn off the hard drive after writing the data from the run to memory.
S5
Shut down, all hardware devices, including power, are turned off.
Appendix II: Common Fault Analysis and Resolution
Fault
Check point
Do not turn on after
powering on
1. Please make sure that the power cable is connected properly
2. Please confirm that the power supply used meets the power supply
requirements of the motherboard(Voltage and Current)
3. Try to re-plug the memory bar(try to clean memory key)
4. Try to replace the memory bar(replace a new Ram)
5. Try to clear the motherboard CMOS according to the motherboard
instructions(take down the CMOS battery and put it in minutes)
6. Please confirm whether there is an external card, go to the exception of the
card is normal
VGA does not
display after
power-on
1. Check if the monitor is turned on
2. Check that the power cord is properly connected to the monitor and system
unit
3. Check that the display cable is properly connected to the system unit and
monitor 4. See if the display brightness control is set to a dark state, and you
can increase the brightness through the brightness control.
For more information, refer to the display operating instructions
5. The monitor is in "power-saving" mode, press any key on the keyboard to
BIOS Setup
Settings can't be
saved
1. Please confirm that the CMOS battery voltage is below 2.8V, if it is below
2.8V, replace the new electricity Pool, reset save
2. BIOS is not set correctly, according to the button of the boot screen prompt
(DEL), in bios
Adjust time and date in Setup
Prompt that a
bootable device
could not be found
1. Please make sure that the hard drive power cord and data cable are
connected properly
2. Please confirm that there is any physical damage to the hard drive
4. SSD is installed in the right port
