Erskine Attachments VP48PD, Руководство оператора по техническому обслуживанию и информации о запасных частях

Страница: 10 / 24

10
ROUTINE MAINTENANCE
Lower the attachment to rest on the ground, shut down the engine, relieve the hydraulic
pressure to the attachment, set the park brake, and wait for all motion to stop before leaving the
operator’s seat to perform service of any kind.
It is the operator’s responsibility to make daily inspections of the loader and attachment for damage, loose bolts,
fluid leaks, or anything else that could cause a potential service or safety problem. Preventive maintenance is
the easiest and least expensive type of maintenance.
IMPORTANT: Bolts and set screws can loosen after initial usage. After the first hour of operation check all bolts
and set screws.
A
B
Use No. 2 lithium base gun grease when lubricating
all attachment grease fittings.
Roll the drum until the weld mark on the motor side is
up, as shown, to position the hub bearing zerks for
greasing.
Grease the two hub bearing zerks
[A] and the two
flange bearing zerks [B] every 4 hours of operation.
IMPORTANT: Do not over-grease bearing. Only add
two pumps of grease every greasing interval.
4
No. 2 Lithium
base gun grease
Clean engine oil
LUBRICATION