Erskine Attachments HP35, Руководство оператора

Страница: 8 / 30

8
MOUNTING INSTRUCTIONS
After the initial set-up assembly is completed use the following procedure to mount the PTO pump to the
tractor for user operation.
1. Mount the tank to the tractor 3-point arms
(Category II or III). Be sure to install the lynch pins
to secure the tank to the tractor.
2. Slide the driveline fully onto the tractor PTO shaft.
Make sure the locking collar is engaged. If the
tractor PTO shield interferes with the installation,
the shield may need to be removed or rotated up.
Always reinstall the PTO shaft
shield when the PTO pump is not connected to
the tractor. See the tractor’s operator’s
manual for instructions.
3. Check to make sure the driveline has enough
overlap and does not bottom out through the
entire range of movement of the 3-point arms. If
the driveline is too short or too long, the 3-point
mount frame can be moved fore or aft by unbolting
and sliding it. There are three different positions
available, each 2” apart.
NOTE: It may be necessary to reposition or
remove the drawbar to prevent interference with
the driveline. See the tractor’s operator’s manual
for instructions.
4. Route the lead hoses over the rear axle, under the
tractor cab, and along the loader arms. Use
plastic cable ties to mount the hoses to the tractor
frame and loader arms.
IMPORTANT: Be sure to route the hoses near
the loader pivot points to prevent the hoses from
being stretched when the loader is raised.
NOTE: Make sure the hoses are properly routed
to fit your specific tractor. If the hoses are not
routed correctly, they may get pinched, stretched,
pulled off, or rub on tires. Be sure to check hose
routing through the full range of motion of the
loader and attachment before operating. More
than one routing may be acceptable depending on
the tractor. Use the routing that best fits your
tractor.
NOTE: Proper hose routing is the responsibility
of the owner and/or operator. Pinched, rubbed, or
stretched hoses are not covered under warranty.