Erskine Attachments HP35, Руководство оператора

Страница: 7 / 30

7
SET-UP ASSEMBLY
After uncrating the unit, use the following instructions to assemble to PTO power unit.
1.
Slide the driveline onto the gearbox shaft of the
pump unit.
IMPORTANT: Make sure the driveline is locked
into the groove of the gearbox input shaft by
pulling on the driveline.
2.
Rest the driveline in the J-shaped hanger.
3.
Place the lower 3-point pins in the appropriate
location to match the hitch category of your
tractor. The inner set of ears are CAT II and the
outer set are CAT III.
4.
The top pin has two positions. The pin should be
mounted in the top hole when connecting the
tractor top link directly to the tank. The pin should
be mounted in the bottom hole when connecting
to the tank using a quick-hitch system.
NOTE: Additional bushings may be needed on
the upper and lower pins if using a quick-hitch
system. These are usually supplied with the quick
hitch and therefore not supplied with the power
unit.
5. Proceed to the mounting instructions.