Erskine Attachments HP35, Руководство оператора

Страница: 12 / 30

12
ROUTINE MAINTENANCE___________________
Lower the attachment to rest on the ground, disengage the PTO, set the park brake, shut
down the engine, remove the key, and wait for all motion to
stop before leaving the operator’s seat to
perform service of any kind.
It is the operator’s responsibility to make daily inspections of the attachment and tractor for damage, loose bolts,
fluid leaks, or anything else that could cause a potential service or safety problem. Preventive maintenance is
the easiest and least expensive type of maintenance.
IMPORTANT: Bolts and set screws can loosen after initial usage. After first hour of operation check all bolts
and set screws.
Cooler Maintenance
Make sure the oil cooler is clean and free of debris
before operating the power unit. If dirty, clean the
cooler fins by flushing them with clean water or
blowing it out with compressed air.
Wear safety gasses meeting ANSI
z87.1 standard when cleaning with water pressure
or compressed air.
IMPORTANT: The filter element (P/N 310999) should
be replaced after the first 50 hours of operation or after
1 year, whichever comes first. Thereafter, it should
be replaced after every 250 hours of operation or after
every 3 years, whichever comes first. More frequent
filter changes may be required based on operating
conditions.
1. Remove the cover bolts with a 10mm socket and
remove the cover.
NOTE: To prevent contamination, wipe the area
around the filter clean before removing the cover.
2. Remove the filter element from the plastic can.
3. Install the new filter element.
4. Reinstall the cover and bolts. Tighten bolts to
maximum 7 ft-lbs. Do not overtighten.
IMPORTANT:
Improper maintenance can cause
extensive damage to the power unit, attachment,
and your equipment.
Oil Change Interval
•
Change the hydraulic oil every 250 hours or every
3 years, whichever comes first. More frequent
changes may be required based on operating
conditions. Be sure to replace with the correct
grade and type of oil for the expected operating
conditions.
•
The drain plug is located on the bottom of the tank.
Tighten the plug after the old oil is drained. Check
for leaks after new oil has been added.
•
Change the gearbox lube every 250 hours or
every 3 years, whichever comes first. Fill to
between 1/3 and 1/2 full (approximately 38 oz.)
with 80W-90 gear lube.