Erskine Attachments 1107080, Руководство оператора

Страница: 8 / 32

8
Wheel Track Remover
Spring Adjustment Holes
MOUNTING INSTRUCTIONS
After the initial set-up assembly is complete, use the following procedure to mount the attachment to the
tractor for user operation.
Mounting to a Tractor
1. Use the step, safety treads, and grab handles to
get on and off the tractor.
2.
Sitting in the operator’s seat, fasten the seat belt
(if so equipped).
3. Drive the tractor to the front of the attachment.
Align the tractor 3-point arms with the attachment
mounting pins.
4. Stop the engine and engage the park brake.
5. Have a second person connect all 3-point links to
the attachment using the pins provided.
All appropriate hitch pins and
locking pins must be locked into place. Failure
to secure pins can allow the attachment to
disconnect from the tractor and cause injury
or death.
6. Adjust the 3-point top link so that the attachment
is level while resting on the ground (see tractor’s
operator’s manual for top link adjustment
instructions).
Wheel Track Remover Adjustment
1.
Raise the attachment 6” to 12” off of the ground
and block in position.
To avoid being crushed, never
work on raised attachment without using
additional support blocks or jack stands.
2. Remove the 1/2" nut and lock washer from the
carriage bolt that holds the spring mount in place,
and move it to the desired depth.
3. Reinstall the nut and lock washer once the spring
mount is in place. Tighten hardware to the proper
torque (see “Bolt Torque Information” on page 29).
NOTE: Softer soil requires the wheel track
remover springs to be set deeper.