Erskine Attachments 1107080, Руководство оператора

Страница: 7 / 32

7
Mounting Plate Standard Position
Mounting Plate Offset Position
MOUNTING INSTRUCTIONS
After the initial set-up assembly is complete, use the following procedure to mount the attachment to the
loader for user operation.
Mounting to a Loader
1. Use the step, safety treads, and grab handles to
get on and off the loader and attachment.
2.
Sitting in the operator’s seat, lower the seat bar (if
so equipped), and fasten the seat belt.
3. Drive the loader to the rear of the attachment. Put
the loader quick attach coupler into the
attachment mounting bracket.
4. Tilt the loader coupler backward a small amount
until it is fully engaged in the attachment mounting
bracket.
5. Stop the engine and engage the park brake.
6. Secure the coupler locking mechanism that
attaches the attachment to the loader.
Coupler wedges or pins must
extend through the holes in the attachment
mounting plate. Levers must be fully down
and locked. Failure to secure wedges or pins
can allow attachment to come off and cause
injury or death.
Mounting Plate Offset
The mounting plate can be offset by 5” to
accom
modate loaders that are wider than 72”. Follow
the process below to offset the mounting plate:
1. Remove the two snap ring pins and slide the
mounting plate off of the hitch pins.
2. Remove the two hitch pins and reverse their
direction so that they are pointing toward the right
side of the attachment.
3. Slide the mounting plate back onto the hitch pins
and reinstall the snap ring pins to secure in place.