G
E
F
A
B
D
C
TC
H
I
0
TEMIS
Quick Installation Guide
MSB-026/04
WARNING
Elements of the complete installation
150
160
170
180
190
150 160 170 180 190
A B
200
210
200 210
140
140
>120°
110°~120°
100°~110°
90°~100°
A
D
C
B
D Aprox
TA
TA
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. The installation manual can be downloaded by going
to the "Downloads" section of Erreka website:
http://www.erreka-automation.com
Electrical Wiring
A.B: 24v DC Motor(2x1mm²)
C: Photocell 2x0.5mm² (max 20m)
D: Control Box (3x1.5mm²)
E: Push Botton 2x0.5mm²(max 25m)
Assembly levels, inward opening
TEMIS It is not applicable to an insecure or lacking rigidity door nor solves the defects due to incorrect installation or mainte-
Check the following points before starting the installation:
1). Hinges are properly positioned and greased.
2). No obstacles in the moving area and no frictions between two gate leafs or with the ground while moving.
3). “C” value is 139mm.
4). “D” can be measured from the gate easily.
5). “A” = “C” + “D”
6). The value of “B” can be calculated from the value of “A” and the leaves opening angle.
Ex. If “A”=160mm with the leaves opening angle of 100 degrees, then the value of “B” is approximate 190mm.
Please make sure B and A are similar or the same in value that the leaves can be
operated smoothly, also to reduce the burden of the motor.
Open Interior
F: Key Selector(2x0.5 mm²)
G: Flash Light (2x0.5mm²)
H.I: Electric Lock (2x1mm²)
TA: Open Stopper
TC: Closed Stopper
1
