PR
LR
PV
LV
Fig. 5
5 - TRANSMITTER MEMORISING
The code of each transmitter key can be memorised into
the receiver in 2 different ways:
A - Directly on the receiver, throught the buttons
PR and PV.
B - By radio, using the transmitter keys only, in self-
learning mode.
5.1A - Direct memorising “Red relay output”
1. Keep pressed down for 2 sec the button PR of the
receiver until the led LR remains lit ;
2.Release PR
3. Within 2 sec. activate the transmitter key which is to
be memorised and check the relay RR activation which
confirms that the memorisation has been carried out.
5.1B - Direct memorising “Green relay
output”
1. Keep pressed down for 2 sec the button PV of the
receiver until the led LV remains lit ;
2.Release PV
3. Within 2 sec. activate the transmitter key which is to
be memorised and check the relay RV activation which
confirms that the memorisation has been carried out.
5.2 - Self-learning memorising Output “Red
relay” ( “Green relay”)
Phase 1
:
Programming request.
Keep pressed down the transmitter keys (A+B) until the
buzzer emits a bip and both the led LR and LV flash for a
while.
Phase 2: Programming enabling
Keep the key A
(B)
pressed down for 4 sec of the same TX
: the led LR remains lit ( the led LV start to flash
)
and the
buzzer emits a long bip
(starts to bip = Bip, Bip, ..Bip)
.
Phase 3: Memorisation
Within 2 sec activate the transmitter key which is to be
memorised.
The led LR (LV) stop flashing and the corresponding
relay excites for a while giving the confirmation of the
memorisation.
Phase 4: Check of the memorisation
Activate the key just memorised and verify the relay
activation RR
(RV)
.
NOTE 1
:
Any following memorisation is allowed only by using
a transmitter already memorised
Example
:
Memorisation of a second TX with keys A on red
relay and B on green relay
- Press A+B on TX1 (bip) ; Press A on TX1 for 4 sec. (Biiiiiiiiiiiip) ;
press A on TX2 within 2 sec.
- Premere A+B on TX1 (bip) ; Press B on TX1 for 4 sec. (Bip, Bip,
..Bip) ; press B on TX2 within 2 sec.
NOTE 2
:
The receiver is set-in-factory for a pulse behaviour of
the relays
For the settings of the relay in step or delayed mode see next
paragraphs.
NOTE 3
:
The memory can store up to 85 transmitter keys.
That means that a 4 keys transmitter uses 4 memory slots.
5.3 - Memory full
If both the leds LV and LR start to flash at the end of
Phase2, it means that the memory is full.
T H E S M A R T L I V I N G
Pag. 15
