ERNITEC ERIS 3000 ADVANCED, Руководство по установке, Страница: 8 / 19

ERIS3000
8
Dome Camera Connection
Dome Camera Connection & Settings:
•
See section Connecting Your DVR for RS-485 port pin definition.
•
Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-
terminals on the RS-485 port by RS-485 cable respectively.
•
To set up dome camera’s protocol and ID, press MENU to access the Main menu, and select
< Camera Setup >. The available protocols include < DynaColor >, < Pelco D >, < Pelco P >,
< AD422 >, < Fastrax 2 >, < JVC >, < Panasonic_C >, < Panasonic_N > and < None > (default).
Note that ID number must match the ID address defined by the dome camera.
•
To configure the RS-485 parameters, select < System Setup > from OSD main menu, and then
select < RS485 Setup >. The default Dyna Guard ™ 090 series DVR RS-485 settings are 9600
Baud, 8 Data Bits, 1 Stop Bit and No Parity.
Dome Camera Control Button:
1. = Preset call and save
2. = Hint screen On/off
Focus/Iris
AUTO
SEARCH = Zoom Out, MENU = Zoom In
SEQ = Focus Near, FREEZE = Focus Far PLAY/STOP = Iris Close, MODE = Iris Open