Ernex AS Norsaw 250, Руководство пользователя, Страница: 9 / 26

9
Fig. 9
Fig. 10
3.3 Connecting main supply
Use an approved extension cord with
ground protection/earth wire diam.
2,5 mm², max. length 25 m.
Tilt the switch and connect power supply
cable.
NB! The switch should always stay in this
position when the saw is in use Fig. 9.
3.4 Connecting of Dust Collector
A dust collector must always be connected to the top guard and the lower blade cover
when using the saw indoors. The extractor should have a capacity of at least 234 m /h -
28 m/sec. The suction connector has a diam. of 38 mm. Remember to cut off the top of
the nozzle on the top guard.
3.5 Transport - carrying-/wheel transport
When lifting the saw with a crane, place slings around the legs on either side of the
machine Fig. 10.
1. Remove extension table (if any) and its locking handles, also remove the push sticks.
2. Remove the fence and make sure that the alu. profile in the table top doesn't stick out on
either side.
3. Remove the top guard by loosening the handle and pull out.
4. Tilt the switch into transport position, lower the saw blade and lock it. Set the saw in
ripping position 90° and lock it in the forward position (seen from the operating side).
5. Tilt the saw down on its wheels (right side) and loosen the locking wheels on the legs.
Fold the front legs first and secure other legs in the clips. Remember to tighten the
locking wheels.
6. You can now pull the saw by means of the handle or carry it by the black handle beneath
the table top Fig. 11 and 12.