Use and maintenance manual
Automatic V-guide notcher
Model: VG-22
____________________________________________________________________________________________________________________
P a g . 6
-
Preparation
NOTE:
Before preparation or change the matrix, always cut the air supply.
Place the profile coil at the rear of the machine, centred by the intake pulley, attaching it to an axle to
allow it to turn and unwind freely.
Begin to pass or insert the end of the profile through the intake pulley, adjusting the top guide pulley
against the profile.
U
nlock the valve to introduce the profile inside the matrix and breaks.
Remove the attachment bolt of the stamping cylinder and withdraw hinge-wise to remove the pressure
cylinder and allow the profile to pass through easily.
