Use and maintenance manual
Automatic V-guide notcher
Model: VG-22
____________________________________________________________________________________________________________________
P a g . 5
NOTE:
ERM Engineering shall not be held liable under any case for damage caused by undue or
improper use of this equipment.
Any repairs or modification of the machine performed by personnel not qualified by ERM
Engineering or use of non-original spare parts provided by persons unrelated to the company, shall
give rise to loss of the manufacturer’s guarantee.
During use of the machinery and industrial use, people are subject to the risk of damage or injury
by mechanical elements in linear or gyrating movement, high voltage electric components and
static components under high temperature, due to which, during design and construction of its
equipment, ERM Engineering has aimed to reduce and minimise those risks by including
protection devices and safety systems based on the European Community Council Directives.
Pay special attention to the following danger, prohibition and obligation signs located at
different places on the machinery:
-
Installation and start-up.
Place the machine where the staff will not be disturbed by the noise during operation.
Leave 1 metre free between the rear and the wall or any other installation, to feed in the profile reels.
Level the chassis using 4 rubber studs or legs.
Supply the machine with air and electrical current.
Connect the machine to the 1 x 230v. Monophase grid.
Air supply connection
Compressed air is also fed through the pressure regulator intake on the left side of the machine, through
a pipe with a minimum interior diameter of 8mm minimum and intake pressure tare between 5 and 7
bar.
