GB-8
D
GB
F
NL
I
E
Gas combination control
First, pull the opened protective cap over the
gas inlet on the gas combination control.
Then pull the right-hand side of the protective
cap over the gas outlet.
Hold together the ends of the protective cap on
the underside and close all the rivets.
Cleaning
CAUTION
To ensure that no damage occurs during operation
and cleaning, please observe the following instruc-
tions. Otherwise, injuries or damage to the device
may occur and/or the function of the device may
be impaired, and the manufacturer’s warranty will
be cancelled.
– Sharp-edged metal sheets. Always wear protec-
tive gloves.
– After cleaning, check that the components on
and in the heater are in good condition. The
device may only be restarted if all safety devices
have been installed and the safety functions
have been checked.
– Clean the heater once a year when used in
horticulture and at regular intervals as well as
after each fattening period when used in ag-
riculture, as described below. Inadequate or
irregular cleaning can cause damage to the
device or lead to fire damage. For example, dirt
particles can catch fire and can be blown out
of the device.
Switch off the burner control unit BCU.
Disconnect the system from the electrical power
supply. The mains plug may only be pulled out
once the device has been switched off and post-
cooling is complete.
Shut off the gas supply.
▷
If the burner control unit and the gas combina-
tion control are not equipped with protective
caps, we recommend cleaning the heater with
compressed air or a damp cloth only.
▷
Equipping the burner control unit BCU and the
gas combination control CG with a protective
cap allows the devices to be cleaned carefully
with a water jet/high-pressure cleaner during
cleaning/disinfection of the animal shed.
▷
To guarantee that the burner control unit com-
plies with enclosure IP 54, make sure that the
screws are tightly secured after wiring and that
the cable glands are closed.
▷
The distance between the nozzle and the surface
to be cleaned must always be at least 50 cm.
> 50 cm
▷
Do not direct the water jet straight at electrical
components such as the vane
.
▷
The water jet from the high-pressure cleaner can
cause serious damage to the components in
the heater. For example, the vane can be bent
or other parts such as the spark plug or rubber
seals can be displaced.
Avoid direct contact.
▷
Do not spray the edges of the protective cap
which are closed using push-in rivets only or
the connection between the burner control
unit and the mounting plate directly with water,
high-pressure cleaning equipment or chemical
cleaning agents.
▷
Do not spray water or chemical cleaning agents
directly into the space between the fan shaft/
impeller wheel and motor and do not clean with
high-pressure cleaners.
▷
Chemical cleaning agents, disinfectants and/or
pesticides contain corrosive substances which
can even corrode stainless steel. Always rinse
the devices with water after cleaning using such
agents to remove any residue of these agents
from the surface.
