Use and maintenance manual
Manual die cutter
Model: F-121
____________________________________________________________________________________________________________________
P a g . 1 8
After the cuts are completed at the first end of the belt, we will remove the belt and, to make the
cut at the other end of the belt, we will adjust the mobile guide to STEP2.
We will lift the clamping bar and introduce the belt the other way around, that is, with the fabric
on top and the covering down to the end of the Nylon plate and well tangent to the initial guide
(
0
) marked with a green dot.
We will lower the clamping bar on both sides of the bench.
We will position the head in position "ST1" to make the first cut of the upper fabric and we will
adjust the pressure regulator knob according to the thickness of the lower fabric.
This graduation for the second end is not related to that of the first end made previously.
NOTE:
For belt types where the exact pressure setting point is unknown, it is recommended to
first perform a cutting test at position ST2, since even if the setting is incorrect, when
performing the second lower fabric cutting operation, the results of this test will be
deleted.
