Heavy Media Permanent Magnetic Wet Drum Separator
5
Tank And Frame Adjustment
The tank and frame assembly should be checked
across the width and length to make sure it is level.
If not, shims should be placed between the frame
pads and supporting foundation.
Installation
ADJUSTMENTS
Magnet Adjustment
The drum and magnet positions are set at the factory
prior to shipment. However, the magnet position
may change during shipment due to road (transport)
vibration, etc. If this occurs the magnetic element must
be re-positioned.
Note that the magnet position is indicated by a scribed
and painted sector on the shaft end. The magnet
position may also be felt by means of a small iron
object held to the drum surface. Optimum magnet
position will be found to vary depending on the
particular operation involved. Generally, best results
will be found with the magnet set so that the centerline
of the discharge pole is slightly above the concentrate
lip. (See Magnet Adjustment Section).
FIGURE 2