Battery Alarm Disable
Start: Disable battery Alarm Tone.
Stop: Restore the original EEPROM setting.
Test Tone
Start: Begin sending test tone.
Stop: Stop sending test tone.
Comment: The test tone frequency is 1000 Hertz.
Soft Boot
Start: Toggles software reset.
Stop: No function.
Comments: Soft Boot will cause the Control Module to reset
to its originally programmed parameters. Immediately after
Soft Boot, either volume key must be depressed to reestablish
communication between the Utility Handset and the Control
Module. The same is true if the RESET switch on the Power
Module is used.
Carrier Control Timer Disable
Start: Disable the carrier control timer.
Stop: Restore the original EEPROM setting.
RUS Disable
Start: Enable Receiver Unsquelched Push to Talk.
Stop: Restore the EEPROM setting of RUS PTT Enable.
Main Rx Enable
Start: Enable the main receiver.
Stop: Restore the original EEPROM setting.
Main Rx Disable
Start: Disable the main receiver.
Stop: Restore the original EEPROM setting.
Aux Rx Enable
Start: Enable the auxiliary receiver and toggle Aux Rx Mute.
Stop: No function.
Aux Rx Disable
Start: Disable the auxiliary receiver and toggle Aux Rx Mute.
Stop: No function.
Aux Control 1 On
Start: Activate Auxiliary 1 output.
Stop: Restore the original EEPROM setting.
Aux Control 1 Off
Start: Deactivate Auxiliary 1 output.
Stop: Restore the original EEPROM setting.
Scan Enable
Start: Enable SCAN.
Stop: Restore EEPROM setting of SCAN Enable.
Scan Disable
Start: Disable SCAN.
Stop: Restore EEPROM setting of SCAN Enable.
Priority Scan Enable
Start: Enable Priority SCAN.
Stop: Restore EEPROM setting of Priority SCAN Enable.
Priority Scan Disable
Start: Disable Priority SCAN.
Stop: Restore EEPROM setting of Priority SCAN Enable.
ADJUSTMENTS
POTENTIOMETER ADJUST MODE
The MASTR IIe Control Module can contain up to 7 digital
potentiometers to set different levels. These potentiometers
must be adjusted properly to ensure optimum station perform-
ance.
To enter the Adjust Potentiometer Mode from the main
menu, press the "A" key.
Select a specific potentiometer by pressing the correspond-
ing number key shown below (see Figure 5):
1 = Line Output Level
2 = Transmit Level
3 = Line Input Level
4 = Channel Guard Level
5 = DSP Line Cancellation Level
6 = DSP Line Input Level
7 = Compressor Level
Ramping switches for these adjustments are shown in
Figure 6.
LBI-38599
A-7
