2
TABLE OF CONTENTS
UNPACKING ................................................................................. 3
ASSEMBLY .................................................................................... 3
This manual is published by Ericsson Inc., without any warranty.
Improvements and changes to this manual necessitated by typographical
errors, inaccuracies of current information, or improvements to programs
and/or equipment, may be made by Ericsson Inc., at any time and without
notice. Such changes will be incorporated into new editions of this manual.
No part of this manual may be reproduced or transmitted in any form or by
any means, electronic or mechanical, including photocopying and
recording, for any purpose, without the express written permission of
Ericsson Inc.
Copyright© October 1993, Ericsson GE Mobile Communications Inc.
3
UNPACKING
When unpacking, be sure all parts are included. The following material
should be part of the kit.
•
Six (6) Dual Rate Charger Units - MHCH3V
•
One (1) Enclosure with retaining cover
•
Two (2) Machine screws with washers and nuts: No. 10-16 x 2.5"
•
Two (2) Thread forming screws: No. 10-16 x 3/4" or (machine screws)
•
One (1) AC Outlet Strip
•
Four (4) self-adhesive rubber feet
ASSEMBLY
REQUIRED TOOLS
•
Phillips screwdriver
•
Pliers or 1/4' nutdriver
ASSEMBLY
1.
Install the AC Outlet Strip to the bottom of the enclosure using the two
machine screws. Insert the machine screws from the bottom of the
enclosure through the two holes and through the mounting holes of the
AC Outlet Strip. Use a washer and a nut on each screw and tighten
securely (see Figure 1, view A).
2.
Insert one of the Dual Rate Charger Units into the enclosure and insert
its AC power cord plug into one of the receptacles of the AC Outlet
Strip (see Figure 1, view B).
VIEW A
VIEW B
Figure 1 - Assembly of 6-Unit Charger
