(or preferably use an existing hole) and insert the cable through the hole. Coil
any surplus cable and tie it out of the way. Be sure to leave some slack in the
cable so the radio may be pulled out for servicing with power applied and the
antenna connected.
Connect the red fused lead to the positive (+) battery terminal, and the
black to the negative (-) battery terminal.
MOUNTING THE RADIO
Use the supplied mounting bracket as a template to locate the positions
for each of the drill holes. After drilling the mounting holes, install the
mounting bracket using the two sheet metal screws provided. Mount the radio
as shown in Figure 3. Be sure to leave enough room at the read of the radio for
the power cable connection.
MICROPHONE
Mount the microphone hangar to the side of the radio using the two screws
provided (or where it will be within easy reach of the operator but will not
interfere with safe operation of the vehicle). Connect the microphone plug into
the microphone connector on the radio and tighten the retaining screws in the
plug.
In some installations an additional noise filter such as Option MGPD1A
may be needed for satisfactory performance.
NOTE
Figure 3 - Typical Installation
