ACeS OG698 Phone User’s Guide
Page 8
Note:
Some features and menus are operator dependent
Version P1C
◗
If a charger is attached but the phone is turned
off the message “Charging Battery Only” is dis-
played
◗
If the phone is on the display will continue to
operate normally
Charging is indicated by the following:
◗
the battery meter in the display is continuously filled and emptied
◗
the indicator on top of the phone shows a steady red light if the phone is off,
green if the phone is on
When the battery is fully charged, the battery meter in the display shows full
and the indicator on top of the phone show a steady green light.
It is possible to use the phone while the battery is being charged. However, the
charging time is increased.
Disconnecting the Charger
1
Disconnect the charger
from the electrical outlet
2
Lift the plug connected to
the phone upwards and pull it
out.
When to Charge the Battery
The nickel metal hydride (NiMH) battery that comes with your phone can be
charged as often or as long as you wish without losing performance. This is not
the case with the nickel cadmium type batteries, often sold as accessories from
other suppliers.
Important!
For optimal talk and standby time, it is recommended that you
use only nickel metal hydride (NiMH) batteries with your phone.
When the battery needs charging the following happens:
◗
An alarm signal (a long beep) sounds and the message Battery low appears
for ten seconds in the display
◗
The indicator light on top of the phone starts blinking red
◗
The alarm may sound again after 10 minutes, depending on the battery type
and how fast it is being discharged
Charging
Battery
Only
#